8V1090.00-2 | B&R Automation | Servo Drive, 3 Phase, Line Filter
Product Description
Material number:
8V1090.00-2
Description:
-
Modular mechanical design using plug-in modules
-
Integrated line filter
-
Integrated braking resistor
-
All connections are made using plug-in connectors
-
Integrated electronic restart inhibit
ACOPOS servo drive, 3x 400-480 V, 8.8 A, 4 kW, integrated line filter, braking resistor and electronic safe restart interlock
Product Information
General information
| B&R ID code | 0x12C8 |
| Slots for plug-in modules | 4 |
| Certifications | |
| CE | Yes |
| UKCA | Yes |
| Functional safety | Yes |
| UL | cULus E225616
Power conversion equipment |
| KC | Yes |
Mains connection
| Permissible network configurations | TT, TN |
| Mains input voltage | 3x 400 VAC to 480 VAC ±10%
3x 230 VAC ±10% |
| Frequency | 50 / 60 Hz ±4% |
| Installed load | Max. 10 kVA |
| Inrush current at 400 VAC | 7 A |
| Switch-on interval | >10 s |
| Integrated line filter per EN 61800-3, category C3 | Yes |
| Power dissipation at device nominal power without braking resistor | Approx. 200 W |
DC bus connection
| DC bus capacitance | 470 µF |
24 VDC power supply
| Input voltage | 24 VDC ±25% |
| Input capacitance | 8200 µF |
| Current consumption | Max. 2.5 A + Current for motor holding brake |
Motor connection
| Quantity | 1 |
| Continuous current | 8.8 Aeff |
| Reduction of continuous current depending on ambient temperature | |
| Mains input voltage: 400 VAC | |
| Switching frequency 5 kHz | No reduction |
| Switching frequency 10 kHz | 0.18 Aeff per °C (starting at 54°C) |
| Switching frequency 20 kHz | 0.18 Aeff per °C (starting at 30°C) |
| Mains input voltage: 480 VAC | |
| Switching frequency 5 kHz | No reduction |
| Switching frequency 10 kHz | 0.18 Aeff per °C (starting at 48°C) |
| Switching frequency 20 kHz | 0.18 Aeff per °C (starting at 18°C) |
| Reduction of continuous current depending on installation elevation | |
| Starting at 500 m above sea level | 0.88 Aeff per 1000 m |
| Peak current | 24 Aeff |
| Nominal switching frequency | 10 kHz |
| Possible switching frequencies | 5 / 10 / 20 kHz |
| Insulation stress of the connected motor per IEC TS 60034-25:2004 | Limit value curve A |
| Max. motor line length | 25 m |
| Protective measures | |
| Overload protection | Yes |
| Short-circuit and ground fault protection | Yes |
| Max. output frequency | 598 Hz |
| Terminal connection cross section | |
| Flexible and fine-stranded wires | |
| With wire end sleeves | 0.25 to 4 mm² |
| Approbation data | |
| UL/C-UL-US | 30 to 10 AWG |
| CSA | 28 to 10 AWG |
Motor holding brake connection
| Response threshold for open-circuit monitoring | Approx. 385 mA |
| Max. output current | 1 A |
| Max. number of switching cycles | Unlimited since implemented electronically |
Braking resistor
| Peak power output | 7 kW |
| Continuous power | 200 W |
Limit switch and reference inputs
| Quantity | 3 |
| Circuit | Sink |
| Electrical isolation | |
| Input - ACOPOS | Yes |
| Input - Input | No |
| Input voltage | |
| Nominal | 24 VDC |
| Maximum | 30 VDC |
| Switching threshold | |
| Low | <5 V |
| High | >15 V |
| Input current at nominal voltage | Approx. 4 mA |
| Switching delay | Max. 2.0 ms |
| Modulation compared to ground potential | Max. ±38 V |
Enable inputs
| Quantity | 1 |
| Circuit | Sink |
| Electrical isolation | |
| Input - ACOPOS | Yes |
| Input voltage | |
| Nominal | 24 VDC |
| Maximum | 30 VDC |
| Input current at nominal voltage | Approx. 30 mA |
| Switching threshold | |
| Low | <5 V |
| High | >15 V |
| Switching delay | |
| Enable 0 → 1, ready for PWM | Max. 100 µs |
| Enable 1 → 0, PWM off | Max. 2.0 ms |
| Modulation compared to ground potential | Max. ±38 V |
| OSSD signal connections | Not permitted |
Trigger inputs
| Quantity | 2 |
| Circuit | Sink |
| Electrical isolation | |
| Input - ACOPOS | Yes |
| Input - Input | No |
| Input voltage | |
| Nominal | 24 VDC |
| Maximum | 30 VDC |
| Switching threshold | |
| Low | <5 V |
| High | >15 V |
| Input current at nominal voltage | Approx. 10 mA |
| Switching delay | |
| Rising edge | 52 µs ±0.5 µs (digitally filtered) |
| Falling edge | 53 µs ±0.5 µs (digitally filtered) |
| Modulation compared to ground potential | Max. ±38 V |
Electrical properties
| Discharge capacitance | 660 nF |
| Energy efficiency (IE classification) | |
| Power dissipation relative to continuous apparent power | IE2 (10,25) 1.6%
IE2 (50,25) 1.6%
IE2 (10,50) 1.8%
IE2 (50,50) 1.9%
IE2 (90,50) 2%
IE2 (10,100) 2.2%
IE2 (50,100) 2.5%
IE2 (90,100) 2.9% |
| Nominal losses in standby mode | 16.8 W |
Operating conditions
| Permissible mounting orientations | |
| Hanging vertically | Yes |
| Horizontal, face up | Yes |
| Standing horizontally | No |
| Installation elevation above sea level | |
| Nominal | 0 to 500 m |
| Maximum | 2000 m |
| Pollution degree per EN 61800-5-1 | 2 (non-conductive pollution) |
| Overvoltage category per EN 61800-5-1 | II |
| Degree of protection per EN 60529 | IP20 |
Ambient conditions
| Temperature | |
| Operation | |
| Nominal | 5 to 40°C |
| Maximum | 55°C |
| Storage | -25 to 55°C |
| Transport | -25 to 70°C |
| Relative humidity | |
| Operation | 5 to 85% |
| Storage | 5 to 95% |
| Transport | Max. 95% at 40°C |
Mechanical properties
| Dimensions | |
| Width | 70.5 mm |
| Height | 375 mm |
| Depth | 235.5 mm |
| Weight | 4.4 kg |
Product Photo
More Products
| X20PS9600 | X20SO6300 | X20DC4395 |
| X20CP0483 | X20SLX210 | X20BT9100 |
| X20CP1483 | X20DI4371 | X20DI9371 |
| x20cp1586 | X20BM05 | X20AT6402 |
| X20CP1583 | X20BC0083 | X20AI4622 |
| X20CP3584 | X20BC8083 | x20at4222 |
| X20CP3583 | X20BB80 | x20bt9400 |
| X20CP1585 | X20BM11 | X20AT2222 |
| X20CP1584 | X20TB12 | X20AO4622 |
| X20CP1684 | X20IF1072 | X20DO9322 |
| X20CP1382 | X20DO6322 | X20IF1030 |
| X20AI1744 | X20DC2395 | X20IF1082-2 |
| X20DI6371 | X20BM15 | X20IF371 |
| X20DOF322 | X20DO4332 | X20CM4810 |
| X20DS4389 | X20DO4322 | X20AI83211 |
| X20PS2100 | X20MM2436 | X20DOF322 |
| X20PS9400 | X20DO8332 | X20PS3330 |
| X20CS1030 | X20DC11A6 | X20BM01 |
| X20CS1020 | X20CM8281 | X20SI9100 |
| X20ATC402 | X20BR9300 | X20SI4100 |
Cooperative Brand
(DCS)
ABB / TRICONEX / FOXBORO/ I/A / HONEYWELL / TDC2000/3000 / YOKOGAWA / BENTLY NEVADA
(PLC)
B&R / ALLEN BRADLEY / BECKHOFF / HONEYWELL / OMRON / SIEMENS
(SENSOR)
IFM / SICK/ P+F/ WENGLOR / BAUMER / LEUZE / HOLLY/ SYSHOKUYO / EUCHNER
(CONNECTOR)
HARTING / PHOENIX CONTACT/ WEIDMUELLER
(VALVE)
SMC / FESTO / +GF+.......
(INSTRUMENT)
+GF+ /E+H / HITACHI / ROSEMOUNT
Why Choose Us
Xiamen ZhiCheng Automation Technology Co., Ltd it is a leading global supplier of control system components. We specialize in control systems and drives. With many years of experience in the industrial sector, we consistently deliver the highest quality of spare parts. We have tens of thousands of spare partsand spare parts warehouse . Products and services to serve for installing of users control system,Distributed control systems, programmable controllers, panel controller and drive!
We major in DCS system,Sensor,PLC,Connector,Valve, and Instrument,MAGNETRON,RO Membrane. With many years of experience in the industrial sector, we consistently deliver the highest quality of spare parts.which make sure that all this jobs are perfectly. If you have any further questions, please don't hesitate to contact us.
How To Contact Me
